Home > Parts > Stock OEM Parts - Honda GX and Chinese OHV
We found 455 results matching your criteria.
Choose a sub category:
Bearings Blocks & Side Covers Bolts, Nuts, Studs, & Hardware
Camshafts & Lifters Charging Systems Crankshafts
Electrical & Switches Fans & Covers Flywheels
Gaskets Gear Reduction Heads, Cylinder
Ignition & Coils Linkage & Throttle Control Misc.
Pistons & Rings Pushrods Recoils & Starters
Rocker Arms Rods, Connecting Seals & Oil Plugs
Side Covers Springs, Valve Valve Covers
Valves & Valve Train Components
All parts are genuine Honda unless otherwise specified
In some cases, New "Take Off" Parts are shipped, chick here for more information


Most GX200/6.5 Clone parts except rod, Piston/Rings, Crankshaft, or Cams will fit Predators
Sort By:
Page of 16
Rod, Connecting, GX200 & AKRA/BSP "Clone", 3.313 +(.010) Extra Long

Clone/GX200 3.313" long stock rod. This is a stock, cast rod that is +.010" over stock length. If the top of the piston is .015" or more down in the bore from the cylinder's gasket surface when the crank is at top dead center using a regular stock length (3.303") rod, this long rod will bring it .010" closer to the top. This will decrease your combustion chamber volume by approximately 1cc which will increase compression and yield .25 to .5 HP to a stocker engine.

Although there is not a specific rule on connecting rod length, AKRA rules have a "catch all" rule of +/-.005" to a known stock part used whenever a spec is not given. This rod is obviously outside those parameters.

Our Price: $12.79
Gasket, Carb, GX390 : Genuine Honda

Genuine Honda

Our Price: $0.29
Nut, M6, Black, Each

Black Coated

Our Price: $0.29
Gasket, Carb, 13/15 hp OHV & 420cc Predators

Fits GX240 to GX390 and most 13/15 Chinese OHV

Our Price: $0.29
Nut, Exhaust, M8 x 12 mm

Uses 12mm wrench. Esp for Hondas & Chinese OHV exhaust.

Our Price: $0.49
Gasket, Insulator GX390, UT2 (Small Port) : Genuine Honda

OEM Honda.
Small Port for UT2

Our Price: $0.49
Nut, M6, Locking, Each

Nylon Locking

Our Price: $0.59
Guide Plate, GX390 : Genuine Honda

For use with Stock Pushrods

Our Price: $0.69
Gasket, Carb, GX200, 6.5 OHV : Aftermarket Replacement (Chinese)

Stock Replacement for 6.5 Chinese OHVs

Our Price: $0.79
Springs, Valve, 10.8 lb., Take Off, Pair : Genuine Honda

Genuine Honda

Fits GX120 to GX200, 6.5 Chinese OHVs, and 212 Predators

Our Price: $1.79
Sale Price: $1.00
Savings: $0.79
Pushrod, GX200, Aftermarket Replacement (Chinese), Each

6.5 Chinese OHV, New in Package or New Take off depending on availability

ALL PUSH RODS ARE SOLD INDIVIDUALLY. YOU MUST 2 PER MOTOR

Our Price: $1.59
Sale Price: $1.00
Savings: $0.59
Pushrod, 212 Predator (old Style), Each

Genuine Honda

Our Price: $5.19
Sale Price: $1.00
Savings: $4.19
Springs, Valve, 10.8 lb, Pair (aftermarket)

Fits GX120 to GX200, 6.5 Chinese OHVs, and 212 Predators

Our Price: $2.00
Sale Price: $1.00
Savings: $1.00
Seal, Crank, GX160, GX200, & 6.5 Chinese OHV : Aftermarket


Fits Seal, GX160s, GX200s, 6.5 Chinese OHV, 212 Predators

Color may vary

Our Price: $1.09
Gasket, Case, GX200, 6.5 hp OHV : Aftermarket Replacement (Chinese)

Stock Replacement for 6.5 Chinese OHVs with 4 Bolt Valve Covers (will not fit Blue or Black Chinese OHVs that have 5 bolt valve covers).

Our Price: $1.49
Rocker Arm, GX200, 6.5 OHV : Aftermarket Replacement (Chinese)

Aftermarket Replacement Part

Our Price: $1.49
Governor Rod

Genuine Honda, New in package or New take off depending on availability

Our Price: $1.59
Bearing, Case, 6205, Chinese 6.5 OHV

New in package or New Take Off Bearings

Our Price: $1.59
Stud, Exhaust, GX160/GX200 : Aftermarket Replacements

Aftermarket for 6.5 OHV, Lifans, and Predators

Our Price: $1.59