Mychron 5 Basic Gauge with Single Temperature, RPM Lead, GPS, Lap Time

ADD TO CART FOR SPECIAL RACER PRICING

Replacement stickers

Allows breather hose to be relocated.

Use for Most Throttle Assemblies. Has Lead barrel on one end only (use throttle stop on other end).

Used as cables stop on our throttle cables.

Thottle Cable for Mikuni Carbs, No Sleeve

Picture for reference only

Great Light at great price. Has NR Racing and contact info engraved on it.

Color May vary

Choice of Colors

Use for throttle set-ups

72". Can be shortened.

Choice of Colors

Univeral Breather. May vary from picture.

(color and shape may vary from picture)

Restrictor Plates for BSP, AKRA, WKA, & other Chinese OHV classes,
Choice of Blue, Purple, Green, or Red

This throttle linkage kit is compatible with most 5.5HP or 6.5 HP OHV Clone (Yellow, Blue, Box Stock Clone [BSP]), Honda GX160 / GX200 Engines, and some Predator 212cc engines.

Black Teflon Coated.

Billet Oil caps, Color May Vary, will fit Hondas only (Hondas Only, does not fit Chinese OHVs)

P.M.I. Mychron Mount (5/8" ID). Steering Shaft mount for the Mychron gauge.

Throttle Cable for Mikuni Carbs, With Sleeve, 67"

Has Curved end with Barrel for attaching to twist throttles.

Economy, lower cost model for the Clone / GX200 Engines.
Mounting Bolts included with purchase

Starter nut for use with handheld starters,
Uses 3/4" Socket, made of steel.
14 X 1.5 mm
Fits GX200s, 6.5 Clones, and 212 Predators
Will not fit GX390s & 420s

P.M.I. Angled Mychron Mount (5/8" ID). Steering Shaft mount for the Mychron gauge.

This Chain Guard/Heat Shield is the perfect addition to a Box Stock, BP, Outlaw engine. The sturdy thermal shield is positioned to help prevent contact between your shoulder and the header, even when you lean on it in the turns. Works with any of the headers ARC carries, but does not work with the stock "box" muffler. Made from 3/16 aluminum and drilled for use with angled motor mounts.

Starter nut for use with handheld starters,
Uses 3/4" Socket, made of steel.
14 X 1.5 mm
Extended Length (66mm long)
Fits GX200s, 6.5 Clones, and 212 Predators
Will not fit GX390s & 420s

Throttle Cable for Mikuni Carbs, With Sleeve, 39"

• Sleeve Length: 39 inches
• Overall Length: 44 inches
• 90° Angle Mount

Throttle Cable for Mikuni Carbs, With Sleeve, 70"

Has straight end with Barrel for attaching to gas peddles

BSP Black Anodized Half Cut Top Plate fits Box Stock Project motors and all similar clone engines. Includes Top plate, Throttle linkage, Brass barrel, Pull Rod, Large Return Spring and Mounting bolts. Holes drilled for mounting your fuel pump which is also available in our store.

Does not fit the predator engine
Does not include cable.

THROTTLE LINKAGE, NR QUICK AND EASY. Note: You must use stock Governor arm. Will work with stock tank (note: actual linkage is slightly different than picture)

Fits Gx120 to GX200s, 6.5 Chinese OHVs, and 212 Predators

Slick one piece design at a very good price.

Extended starter nut for use with handheld starters, Uses 3/4" Socket. Steel.

Low cost method of recording hours run!!!