Fits: GX200, GX390, and All Chinese OHV's. Available in various thickness.

Available to Various Sizes

For use with Stock Pushrods

Used to raise stud when using (billet rockers) to get more height to correct valve train geometry.

Bolt, 1/4" Self Tapping 10 mm Head, for Gov Hole.

Use with 3/8" Bolt to seal hole when removing Oil Sending Unit,  Each

Use to plug switch hole cover in shroud when switch is not used. Each

For use with 1/4" Chrome Moly Pushrods

For use with Stock Pushrods

For use with Stock Pushrods

Reduces case flex.

Available for:
GX160/200
GX270/390

Fits all GX120s, GX200, & UT1 and prior GX160s
Will not fit UT2 GX160s

Short Reach plug for excessively milled heads.

Genuine Honda For use with 3/16" Chrome Moly or Alumimum Pushrods

Boot, Sparkplug, Rubber, Non- Resistor. Color May Vary

Fits UT2 GX160s.
Will not fit GX120s, GX200, or UT1 and prior GX160s

OEM Honda Aluminum 3/16" Pushrod, UT2 GX160s

Stock Replacement for all 6.5 Chinese OHVs using 24mm x 5.5mm stems.

Will fit 69730 Predators
Will not fit Hemi Predators or 69727 CA Predators

Replacement for valve kits.

Aluminum Retainer for use with 18 & 26lb Springs
(Sold each, keepers not included)

Aluminum Retainer for use with 30 & 37lb Springs
(Sold each, keepers not included)

THESE ARE PISTONS DAMAGED IN SHIPPING AND HAVE NICKS & SCRATCHS ON TOP OF PISTON
THEY ARE FULLY USABLE JUST NEED SOME TOUCH UP.

For use with 3/16" Chrome Moly Pushrods

Retainer, Aluminum for use with split keepers, for use with HD/Dual Springs & SS Valves. 6.5mm Valve Stem.

Boot, Sparkplug, Rubber, NGK Resistor.

Use only with Black HD retainers.
Sold as a pair (2 keepers) to do 1 Valve

Aluminum Retainer for use with Dual Springs
(Sold each, keepers not included)

Use to increase spring pressure with aluminum retainers 5.5mm Stem (GX200, 6.5 Clones)

Sold as a pair (2 keepers) to do 1 Valve

Offset timing key used to advance timing on all Hondas and Chinese OHVs. 2, 4, 6,  8, & 12 degrees