Use to drill your own jets, Choose Drill Bit Size:

use to measure rod clearance

Low cost and effective valve notcher for Hemi Head 212 Engines.

Works with hand held drill. Instructions included.

Inexpensive way to lap valves

12 pt 5/16", 3/8" Drive for ARC Rod Bolts


Picture for referenec only. Band or markings may vary

`1/4" 12pt, 1/4" Drive for ARC Rod Bolts

Package of 10 inserts.  Tap, Drill bit, and Insert tool (not included.

Use for setting valve clearance.
Has 9 leaves,  0.0015, 0.002, 0.003, 0.004, 0.006, 0.008, 0.010, 0.012, 0.015

Sets consist of 1/2" wide leaves nested in a
steel frame. Each leaf is clearly marked with
the thickness. A lock keeps individual leaves secure
in any position

Package of 10 inserts.  Tap, Drill bit, and Insert tool (not included.

Awesome kit for drilling Methanol and large gas main jets.

Size range .038" to.067" (#51 to #60)

• 1/4" quick-change hex shank - lightning-fast bit swaps, fit impact drivers, extensions
• Hard-to-find mini sizes #51, 52, 53, 54, 55, 56, 57, 58, 59, & 60
• Durable high-speed steel for cutting power & strength
• PVC sleeve to keep bits organized & easy to identify

Used when head is installed, Quickly inserts through the spark plug hole to set a degree wheel.  Used as a positive stop for setting up degree wheel.

Use to remove hone marks and cross hatching from rods and pistons. Kit contains 2 fine small and 2 fine large wheels, and mandrel

240 Grit. For light Material finish

Used to lengthen dowl pin hole when milling heads.

Package of 5 inserts.  Tap, Drill bit, and Insert tool (not included.

240 Grit. For light Material finish

For 200 Big Bore Motors

For GX120 to 200 (2.75" max bore)

Fits GX120 to Gx200s
For light material removal

Genuine Honda.
Fits GX120 thru GX200s and most 6.5 OHV, & 212 Predators

Genuine Honda. Fits GX270 & GX390s (also most Chinese 13/15hp & 420s)

The best way to remove a flywheel. Just remove the nut, screw knocker on end on crank, smack with a hammer. No puller needed, eliminates cracked flywheels from pullers.
Approx 8" long and weighs 1 lb 6 oz

(note: knocker must not be fully seated against flywheel, leave at least 2 or 3 turns out)

GX120 to 200, 6.5 Chinese OHVs

The best way to remove a flywheel. Just remove the nut, screw knocker on end on crank, smack with a hammer. No puller needed, eliminates cracked flywheels from pullers.
Knocker is 8" Long and weighs 1 lb, 6 oz

(note: knocker must not be fully seated against flywheel, leave at least 2 or 3 turns out)

GX240 to GX390, 13hp Chinese OHVs

For light material removal

For light material removal

#35 Chain Breaker w/ handle (black Oxide finish)

600 Grit. For Ultra fine finish or  plateau  honing

Low cost and effective valve notcher for Hemi Head 212 Engines.

Works with hand held drill. Instructions included.

6 Inch

Use in drill to lap valves in. The easiest and quickest way.